DIY Low Power Serial Console Servers, on a Shoestring Budget

I try to keep my home computer setup minimal, low power and out of sight. There is no dedicated computer space, everything is either portable, resides in the media centre and/or runs headless by default. It’s is great for keeping the house neat, but a pain when something goes wrong and I need to debug it in place.

For years, I had kept a USB serial cable ready to go beside the Soekris router, in case I needed to get in the console. But hauling the floating monitor up to the attic whenever the NAS had an issue became an inconvenience. So I came up with an idea from my professional life, console servers.

But there were two problems, what cheap, low power device to use, and how to get a serial port on the NAS? Turns out the second question was easily addressed when I noticed the COM connector in the main board in the NAS. I just needed to add a DB9 connector, or so I thought. Despite trying a variety of settings and speeds, I could never quite get the output at the correct speed and settings, which is a solvable problem, with enough time. I was prepared to live without serial support into the BIOS.

For the low power devices themselves, I considered SheevaPlugs, GuruPlugs etc but always held off since I didn’t want to have to spend over €100 (plus shipping) for each device. So I kept hauling the monitor around, up until last year when the Raspberry Pi was released. The 1 unit per order slowed me down for a few months, but I managed to amass 3 of them (2 console servers, and 1 toy) by the end of 2012. I got a handful of 16GB, recognizably branded SD cards from Amazon and I was making progress. I also needed cases for them, since the Soekris is in a cat accessible places, and I’m sure a cat would be curious about a circuit board at some point. So I got 3x of the elegantly designed AdaFruit cases from a UK reseller^Wcutter, which did the job very nicely indeed.

The result?


3 Raspberry Pis, in cases

I now have a Raspbian (eventually I’ll swap it out for FreeBSD after some testing) console server on my Soekris, which has already been invaluable flashing it’s BIOS and getting in via the console via SSH. I have another Raspberry Pi in the attic, ready for action once I solve the serial port issues on the NAS (which is in progress, but worthy of it’s own post). I’m even toying with a 3G modem on the Raspberry Pi on the Soekris as a complete out of band solution to fixing my home internet when I’m not there. Once I get that working, I’ll declare my home network over engineered. 🙂

One thought on “DIY Low Power Serial Console Servers, on a Shoestring Budget

  1. That over-engineering is totally doable, too, hah. The difficult bit is probably working around the various providers’ terrible interfaces, if my 3G experience with Meteor is anything to go by.

    I’m jealous of you, with rental accommodation that varies too often it doesn’t make sense to have a moderately complicated static network setup in that way. Oh well, working on that problem too, and all that overtime that my colleagues are complaining about in the papers means I’m making a dent in my loan as well, which means I’m substantially happier than I was this time last year 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *